frikin_bike!

so your something went wrong with your pull start... or your putting in a metal paw. well heres a tutorial that'll put it back together in no time unless you have no clue on how it works. AND PLEASE HAVE ADULT SUPERVISION WHILE HANDLING THE COIL!!! I've had bad experiences with it and alot of bandaids.

-make sure all parts are there. there are 5 pieces in the middle where the bolt is.( the first picture is of a bolt and washer, spring, and a round piece of plastic. the second is of the paw)



-You take the circular piece that has the cord connected to it and the coil and wind it on the back side. you'll see a hook on the ends of the coil and a notch where it connects to. just don't let go of the coil cuz it will spring back. The thrid picture is that it should look like. then place it inside then wind it up clock wise till you can't do it anymore you'll notice that the cord didn't go tight so we'll get to that in a bit. put all the pieces in middle with the paw in first then put the rest in like in picture 4 and tighten the bolt so its snug and not tight cuz then you'll have to pull harder and the cord might not go back in.

-You'll see a notch on the edge on the wheel with the cord on it. take a screw driver and pull some of the cord out and place it in the notch and turn it counter clockwise for one whole turn then place it back in the wheel.

That should do it for putting it back together... It might take you afew times to get the hang of it to put her back together. If there are any problems with this tutorial please tell me so I can fix it

Attached Images

	IM000850.jpg (36.4 KB, 33 views)
	IM000862.jpg (45.7 KB, 23 views)
	IM000855.jpg (30.5 KB, 33 views)
	IM000846.jpg (19.8 KB, 30 views)

__________________
winners never win, the people that take you down and take your flag. They are the winners