inthelead83

hey there, this tutorial is about replacing your o rings for a c1, c2, or any kind of blata/ blata rep. motor.

1. remove the motor out of the bike and take off the cylnder, so it looks like this



2. remove the 6 screws holding the head on which are located in the holes ontop(duh eh)



so then it will look like this



3. take those orings out i recommend those tools that the dentists use for cleaning your teeth ya know they works very well. and then take out the done you can do this by hitting it with a rubber mallot so it now looks like this



4. next there is a hidden oring in the head located here:



5. when putting the new orings in i have heard suggestions of using loctite or silicone i have used both and they work do not use too much though if there is any excess ontop whipe it off.

6. so now you can re-assemble put the dome back in the head, bolt the head onto the cylnder, bolt the cylnder back onto the crank case, then put the motor back in the bike!

__________________
RCMRRA - Vice President
Proud Owner of:
Modded Blata b1 Origami, Blata Elite 11, & Moto-Vert
www.rcpra.net

3rd Place overall in CCMRRS 50cc pocketbikes
3rd Place overall in CCMRRS Open Mini Motard